Hach Lange 2100AN, Instrument Manual

Page: 71 / 108

SECTION 6,
continued
71
6.4.2 Printer Setup Commands
6.4.2.1 Printer Speed Selection
The 2100AN Turbidimeter can be configured for fast or slow (2.5 second delay)
print speed.
1. Enter the setup mode by pressing
SETUP
. The small LED mode display
will flash.
2. Select the number
01
using the up, down and right arrow (edit) keys.
3. Press the
ENTER
key to activate the print speed selection mode. Use the up or
down arrow keys to select the flashing
FAST PRT
for fast or
SLOW PRT
for
slow print speed.
4. Press the
ENTER
key to accept the desired setting.
5. Press
SETUP
to exit the setup mode. Pressing
UNITS/EXIT
at any time, prior to
accepting the new print speed setting, exits the printer setup mode leaving
original settings intact.
6.4.2.2 Printer Output Selection
1. Enter the setup mode by pressing
SETUP
. The small LED mode display
will flash.
2. Select the number
02
using the edit keys. Press the
ENTER
key to go into the
printer setup mode.
3. Toggle through the
INT
(the built-in printer),
EXT
(the RS232 connection), or
BOTH
printer outputs using the edit keys. Press the
ENTER
key to select the
desired output.
4. Press
SETUP
to exit the setup mode. Pressing
UNITS/EXIT
at any time, prior to
accepting the new output setting, exits the printer setup mode leaving original
settings intact.
6.4.2.3 Print Interval Setting
1. Enter the printer setup mode by pressing
SETUP
. The small LED mode display
will flash.
2. Select the number
03
using the edit keys followed by
ENTER
.
MM-SS IVL
is
displayed with the left digit flashing.
3. Set the minutes and seconds (
MM-SS
) for the automatic print interval time
using the edit keys (
00-15
to
99-99
). To disable the print interval setting, select
00-00
. Press
ENTER
to accept the new setting.
4. Press
SETUP
to exit the setup mode. Pressing
UNITS/EXIT
at any time, prior to
accepting the new value, exits the setup mode leaving original values intact.