Hach AV9000S, User Manual

Page: 14 / 164

Figure 8 Avoiding silt when mounting the sensor
1 Water 3 Sensor
2 Pipe 4 Silt
Operation
For sensors connected to an FL900 flow logger, connect a computer with
FS
DATA Desktop software
to the flow logger to configure, calibrate and collect data from the sensors. Refer to the
FS
DATA
Desktop documentation to configure, calibrate and collect data from the sensor.
For sensors connected to an FL1500 flow logger, refer to the FL1500 flow logger documentation to
configure, calibrate and collect data from the sensors. As an alternative, connect a computer with
FS
DATA Desktop software to the flow logger to configure, calibrate and collect data from the
sensors. Refer to the
FS
DATA Desktop documentation to configure, calibrate and collect data from
the sensor.
For sensors connected to an AS950 sampler, refer to the AS950 sampler documentation to
configure, calibrate and collect data from the sensors.
For sensors connected to a Sigma 910, 911, 920, 930 or 940 flow meter, connect a computer with
InSight software to the Sigma flow meter to configure, calibrate and collect data from the sensors.
Install the software
Make sure that the latest version of the
FS
DATA Desktop software or InSight software is installed on
the computer as applicable. Download the software from http://www.hachflow.com . Click Support,
then select Software Downloads.
Configure the sensor
For sensors connected to an FL900 flow logger, configure the sensors with the
FS
DATA Desktop
Setup Wizard. Refer to the
FS
DATA Desktop documentation for instructions.
14 English