HACH LANGE 9184sc, User Manual, Page: 23 / 50

21
Operation
4.6 Calibration
4.6.1 Temperature Sensor Calibration
The probe contains a temperature sensor which is factory pre-set. If there are setting
questions, the data can be validated using a high precision thermometer using
Table 1
and performing the steps in section 4.6.1.1 on page 22 .
DISP PH FORMAT (9184sc T.F.C or 9184sc Ch Acid only)
Choose either XX.XX pH or XX.X pH.
pH MAXIMUM (9184sc T.F.C only)
Allows user to set the maximum pH allowed value. An higher value will display a PH TOO HIGH error message.
LOG SETUP
Allows user to select data logging interval for the sensor and temperature.
FILTER
Adjust for + s. This averages the signal over the specified time interval.
MAINS FREQ
Choose 50 or 60 Hz.
CONFIGURE (continued)
DEFAULT SETUP
Resets the sensor configuration to default settings.
DIAG/TEST
PROBE INFO
Displays the driver and software versions and the serial number.
CAL DATA
Displays OFFSET: °C, SLOPE: in A/mg and OFFSET: uA, SLOPE: %
SIGNALS
Displays INT, TEMP RAW, MV RAW and PH RAW.
COUNTERS
Displays sensor total time and humidity suppressor.
4.5 Sensor Setup Menu (continued)