habitat et jardin Netto, Manual

Page: 9 / 20

8
(2)The cleaning steps of small micro filter bag or bigger micro filter bag (A-B-C-D):
(a)Rotate the both fixing knobs (each beside the filter bag) in same direction to 180 degrees, pull out
the basket and filter bag from the rear of pool cleaner.
(b)Detach the filter bag from the filter basket.
(c)Clean the filter bag and filter basket.
(d)Install the filter bag back to the filter basket
.
5.3 Check whether there is garbage on the impeller. If it has, take out the garbage, and clean the
impeller.
Take care not to touch wires together or allow them to contact any metal items, which would cause
sparking and/or short circuit the battery.
Never smoke or allow a spark or flame in the vicinity of the cleaner, batteries can generate gases
which could possibly ignite.
Do Not expose to fire or intense heat as this may result in an explosion.
A battery can produce a short circuit current high enough to weld a ring (or like item) to metal causing
a severe burn.
Wear complete eye protection, gloves and protective clothing when removing the battery pack.
CAUTION!
If a battery leak develops, avoid contact with the leaking acid and place the damaged battery in a
plastic bag.
If acid comes in contact with skin and clothing, wash immediately with plenty of soap and water.
If acid comes in contact with eyes, immediately flood eye with running cool water for at least 15
minutes. Get medical attention immediately.
WARNING!
Never attempt to disassemble a lithium battery.
Remove all personal items such as rings, bracelets, necklaces and watches when unwiring a lithium
battery from the vacuum unit.
6.1 BATTERY DISPOSAL
Your Rechargeable Pool Vacuum Battery is a lithium battery which must be disposed of properly is
required, please contact your local authority for information.
6. Battery assembly and replacement
(1) Push the button forward along the arrow direction, until it not stuck the slot of the connector.(as
picture “A” shows)
(2) Holding the body while reversing the connector , and removing the battery mounting from the
body.( as “b1”“b2” in picture “B” shows)
(3) Remove the used battery, and replace new lithium battery. Connect the battery and the fastener in
the battery holder first, see the place “c1” “c2”on picture “C”, then put in the battery.
Note:Please don’t pull the battery group heavily , and unlock the battery and the fastener,Fig[
b3]
Note:The battery should be in right place, about 10mm from the connection port, the wire in
the unoccupied place of the side.(see “c3” in picture “C”)
6.2 The steps of changing the battery
D C B A
OPEN
CLOSE