Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Regulating Unit PMR-07
Author:
A.T. / KM
REGULATIONS AND GENERAL WARNING NOTES
Edition: 04/2006
Page
A-9
Replaces: 10/2005
A.6
SAFETY WARNINGS
When using industrial machines and systems, one should be aware that moving mechanical
parts (linear or rotary movement), high voltage electrical parts, and any parts at high
temperature, etc, can cause serious damage to persons and materials.
In designing and building the regulating unit, the Manufacturer focused special attention on
safety in order to supply a SAFE regulating unit and, therefore, the Manufacturer has provided
protective and safety devices considered necessary according to the Risk Analysis carried out
by expert personnel. People in charge of system safety must make sure that the following
essential safety regulations are observed:
Do not run the regulating unit with the fixed and mobile protective devices
dismantled or disabled.
Do not run the regulating unit with the fixed and mobile protective devices
dismantled or disabled.
It is forbidden to switch off safety devices installed on the regulating unit
or create by-pass systems to limit switches or micro-switches.
Operations with reduced safety devices must be carried out strictly
observing the instructions in the relevant descriptions, and must be
performed by specialized technicians aware of the risk, under the direct
supervision of the company person responsible for safety. Active
protective devices must be restored as soon as possible, limiting this high
risk status to the minimum.
Cleaning and maintenance operations must be performed with the
electrical and pneumatic cutout devices switched OFF. To this end, the
regulating unit is provided with emergency push buttons which shut down
the system. It is good practice to use them as safety lock-outs to avoid
accidental starting during inspections or mechanical jobs.
Clean covers and control panel with soft, dry cloths lightly dampened in
detergent; do not use solvents as they could damage the surfaces.
Do not modify the regulating unit or its parts. Otherwise, the manufacturer
shall not hold itself responsible for damage to persons and materials.
Request any modifications/customizing directly from the manufacturer.
OF
Regulating Unit PMR-07