Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Hot Press PM-306/160
Author:
A.T. / KM
OPERATION
Edition: 09/2005
Page
D-14
Replaces:
D.6
Troubleshooting
ATTENTION
Maintenance, repairs and replacement operations for electrical components must be carried out by an
ELECTRICAL MAINTENANCE TECHNICIAN or a QUALIFIED TECHNICIAN able to perform the tasks in
accordance with safety regulations.
T
ABLE
16
-
T
ROUBLESHOOTING
Faults Solutions
No air
Check for air in the supply line.
No current
Check that the main switch is in "ON" position.
Fault in temperature
rise (Probable presence
of liquid in the cooling
circuit)
- Disconnect all electrical supply.
- Disconnect the tubes that bring water into the hot-pressing device.
- Empty the cooling circuit using jets of compressed air.
ATTENTION -
When expelling water with compressed air, make sure no
water comes into contact with any of the electrical equipment.
Electrical faults
If a fault develops in the control/regulatory electronic unit, in the first place the
automatic switches in the regulating unit should be checked.
The automatic switches control output and are accessible from the outside.
Supplementary automatic switches to control command current are located
inside the regulating unit.
Hot-pressing device PM-306/160
