Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Hot Press PM-306/160
Author:
A.T. / KM
INSTALLATION
Edition: 09/2005
Page
C-4
Replaces:
C.2.2
Handling – Mobile use
To make transportation of the hot-pressing device easier it can be dismantled as indicated:
If connected, disconnect the various electrical, water and air connections.
Disassemble the upper part of the press (1) (the support with the heating element).
Disassemble the lower part of the press (3) (the support with heating element).
Disassemble the heat equalizing plate with clamping device (5).
Use suitable handling and transport equipment capable of dealing with the object's weight, while taking
care during the transportation itself.
Reassemble the hot-pressing device and ensure that its mechanical parts are functioning properly.
Reconnect the power while taking special care when handling electrical power sources close to the water
used in the cooling system.
The hot-pressing device can also be moved as a single unit, in which case the following must be
carried out:
If connected, disconnect the various electrical, water and air connections.
Use transportation equipment of the correct capacity for the weight of the object to be moved.
Verify that the hot-pressing device and all its mechanical parts have not been damaged in transit and that
all are working correctly.
Reconnect the power while taking special care when handling electrical power sources close to the water
used in the cooling system.
ATTENTION
ALL OPERATIONS MUST BE PERFORMED BY PROPERLY TRAINED AND EXPERT PERSONNEL.
ATTENTION
ALL HANDLING OPERATIONS OF THE HOT-PRESSING DEVICE MUST BE PERFORMED SLOWLY
WITHOUT ANY SUDDEN MOVEMENTS, TO AVOID TO DAMAGE PERSONS AND MATERIALS.
Hot-pressing device PM-306/160
