Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Hot Press PM-1606
Author:
S.D.T. / KM
INSTALLATION
Edition: 02/2005
Page
C-3
Replaces: 01/2002
C.2
Packing and handling
ATTENTION
C.2.1
Handling – Stationary use
The movement of the packaging and machinery should be carried out by authorized operators.
Suitable equipment must be used to move the hot-pressing device, with adequate strength to deal with
the weight and bulk of the hot-pressing device.
When unpacking, check that no small parts remain in the case, and carefully check the general
conditions.
In transit, or on being moved, the hot-pressing device must be disconnected from any control or
regulating units.
There are two handles at the side of the hot-pressing device for lifting the equipment. The fastening rods
at each end of the hot-pressing device must be evenly locked before hoisting.
Never use any hooking points other than the specific (3) eye-bolts when hoisting the hot-pressing device.
The fastening rods (4) must be correctly closed.
Concerning disposal of packing materials, the user must observe the current laws of the country of
installation.
IMPORTANT
REPORT ANY DAMAGE NOTED ON THE HOT-PRESSING DEVICE AT DELIVERY TO THE
CARRIER AND SUPPLIER.
Packing materials (wood, nails, plastic, barrier bags, etc.) can be sources of danger and should be placed
in collection points, especially if polluted or non-biodegradable.
The user must observe the waste disposal legislation in the country of installation when disposing of the
packaging.
ATTENTION
ALL HANDLING OPERATIONS OF THE HOT-PRESSING DEVICE MUST BE PERFORMED SLOWLY
WITHOUT ANY SUDDEN MOVEMENTS, TO AVOID TO DAMAGE PERSONS AND MATERIALS.
Hot-pressing device PM-1606
