4
The chimney (fireplace or flue) must be made of
stainless steel or ceramics (glazed internally) and
suitable for
wet operation
so that it cannot rot.
The pellet stove cannot be connected to the mains
electricity until it has been correctly connected to the
fireplace.
The pellet stove may not be installed in the open
air!
Attention!
The mains cable plug must remain freely
accessible after installation.
The pellet stove may only be operated with standard
wood pellets (6 mm diameter). (See Section 7.1
“Fuel”).
The protective grille located in the pellet container
must not be removed.
Attention!
The Pelletto stove may only be
operated with the tank cover closed.
Placing non-heat-resistant materials or objects on
the stove or within the specified minimum distances
is forbidden. Here please note in particular that
during “Standby” operating status, the stove may
unexpectedly and unintentionally start heating when
the room temperature falls below the desired
temperature.
Never use liquid fuels to ignite the pellet stove or to
revive existing embers.
With the burning up of fuels, heat energy is
released, leading to strong heating of the heating
device’s surfaces (e.g. doors, door and control
handles, viewing window panels, side walls, front
wall, flue tubes). Touching these parts without
suitable heat protection gloves or a tool is to be
avoided!
The device ignites
by itself in “Standby” mode.
Because of the heat generated on the panel, make
sure that no-one who is unfamiliar with the operation
of the pellet stove is unsupervised in the room where
it is installed.
Bring these risks to y
our children’s and guests
attention!
In particular, any cleaning staff should be informed
and instructed regarding the possible unexpected
heating up of the stove.
Placing non-heat-resistant objects on or near the
heating device (even when it is cold, since it can
ignite again by itself) is forbidden!
Do not lay any laundry on the stove to dry!
Clotheshorses for drying clothes and the like must
be positioned at sufficient distance from the heating
device
– fire risk!
When operating your heating device, it is forbidden
to work with highly flammable or explosive
substances in the same room or an adjacent one!
3. Installation of the pellet stove and connection to
the chimney
The packaging on your new pellet stove gives it optimum
protection against damage. Nevertheless, damage may
have occurred to the stove or to accessories in transit.
Please therefore check your stove after unpacking for
damage and completeness! Report any defects or
anything missing to your specialist stove dealer without
delay!
Remark: Combustion chamber cladding that is loose or
has come off its fastenings and the like are not defects.
(
See Section 7.2. “Commissioning your pellet stove”).
The packaging on your stove is by and large
environmentally neutral. The timber packaging is not
untreated. The timber, the cardboard and the films can
be taken without problems to your local recycling centre.
For the correct operation of your pellet stove it is
important that it stands horizontally.
The room temperature sensor that is located on the back
wall has a length of about 1.5 m and should be
positioned hanging free at the back.
Figure 1: Back connections
1 = Mains cable
2 = Data cable connection
3 = OC overheat cutout
4 = Fume elbow 80 mm
5 = Outside air connection 60 mm
6 = Room temperature sensor
7 = back wall
