Haas Automation EC Series, Control Book

Page: 110 / 127

103
January 2004
Revised on 02-21-04
HAAS MILL CONTROL TIPS
GENERAL TIPS
D Cursor Searching for a Program - When in EDIT or MEM mode, you can select and display another
program quickly by simply entering the program number (Onnnnn), and pressing, cursor arrow down or F4 .
D Searching for a Program Command - Searching for a specific command in a program can be done in
either MEM or EDIT mode. Enter the address letter code (A, B, C, etc.) or address letter code with the value
(A1.23), and press the up or down cursor arrow. If you enter just the address code and no value, the search will
stop at the next use of that letter, regardless of the value.
D Spindle Command - You can stop or start the spindle with CW or CCW any time you’re at a Single Block
stop or a Feed Hold. When you restart the program with CYCLE START , the spindle will be turned back on to
the previously defined speed.
D Coolant Pump - The coolant pump can be turned on or off manually while a program is running, by pressing the
COOLNT button. This will override what the program is doing until another M08 or M09 coolant command is ex-
ecuted. This also applies to the chip conveyor.
D Coolant Spigot Position - The coolant spigot position can be changed manually when a program is run-
ning, with the CLNT UP or CLNT DOWN key. This will override what the program commands until another
spigot position is commanded with an Hnn or M08 command.