10
12.3 Installation instructions
Make the mounting holes according to the design of the component. The mounting holes should be
arranged as shown in the diagrams (cf. section 20:
Dimensions
) and the drilling template.
Built-in version:
To support the delivery of a drilling template assembly is attached.
Figure shows HST-M2 Ident.-No.: 10649
Assembly group
A
Lock
B
M3 screw
C
Protective cap
D
Switch key
E
M5 screws
F
Nut and plate for M5
G
Seal
H
Switch
I
Control panel or machine housing
Remove the keys [D] if necessary by manually actuating the locking element (lifting magnet).
Remove the protective caps [C] after unscrewing the M3 screws [B] from the lock [A].
Pass the HST-M from behind through the mounting holes in the control panel or machine
housing [H].
Attach the HST-M with 4 sufficiently long M5 screws [E] and matching nuts, washers [F].
Secure the screw connection against coming loose.
Carry out the electrical connection (cf. section 12.4)
Attach the protective caps [C] back onto the locks. Take note that the caps for the protection
rest in alignment with the locks [A] for removed keys [D]
No liability is accepted in the event of improper installation!
A
B
C
D
E
H
F
G
