| SERVICE MANUAL / INSTALLATION GUIDE
© HAAG-STREIT AG, 3098 Koeniz, Switzerland
–
HS-Doc. No. 7220676 - Edition 2.00 / 2020
9
Install the battery to the FUNDUS MODULE 300 as
instructed in the Appendix B.
Place the FUNDUS MODULE 300 to the cradle for
charging.
The FUNDUS MODULE 300 will fit into the cradle
when front part is positioned onto the support and rear
part is carefully moved into the connector. Excessive
force shall be avoided in order to prevent the camera
and the cradle connectors from breaking.
Charge the battery for 4 hours before the first use. In
daily use charge the battery when battery level is low.
Charging battery at any level is not harmful for battery.
Fig. 10
3.3
Attaching the label for automatic left/right detection
NOTE!
Clean the table surface before positioning the side identification sticker (1022535) Make sure that no
oil and grease residue remains on the surface.
NOTE!
Make sure you use side identification sticker 1022535 together with RM02.
6.
Rail cover
7.
Protective film
8.
Roller rail
9.
Table
10.
“Positioning tool” sticker
Fig. 11
•
Remove the rail cover (6) and move away the slit lamp. Clean the surface of the table.
•
Remove protective film (7) from the back of the sticker. Start lifting it off carefully from the corner opposite the
black area.
•
Position the sticker against the right roller rail (8) and the edge of the gliding plate (9). Press the white/black
surface, smooth out air bubbles.
•
Carefully tear off the remainder of the adhesive label along the perforation (10).
•
Mount the slit lamp and rail cover again.