H3C WA6638, Manual

Page: 11 / 14

2-8
Figure 2-15 Connecting a power injector
Check after power-on
Examine the LEDs on the AP after you power on it to verify that the AP is operating correctly. For
more information about AP LEDs, see "
LEDs ."
Connecting the AP to the network
To connect the AP to the network, connect the 10GE/PoE++ port on the AP to an Ethernet switch.
All AP settings are configured on the AC. To verify the network connectivity of the AP, execute the
display wlan ap all command on the AC. If the AP status is R/M , the AP has been connected
to the network.
<AC> display wlan ap all
Total number of APs: 1
Total number of connected APs: 1
Total number of connected manual APs: 1
Total number of connected auto APs: 0
Total number of connected common APs: 1
Total number of connected WTUs: 0
Total number of inside APs: 0
Maximum supported APs: 64
Remaining APs: 63
Total AP licenses: 16
Local AP licenses: 16
Server AP licenses: 0
Remaining Local AP licenses: 15
Sync AP licenses: 0
AP information
State : I = Idle, J = Join, JA = JoinAck, IL = ImageLoad
C = Config, DC = DataCheck, R = Run, M = Master, B = Backup
AP name APID State Model Serial ID
ap1 1 R/M WA6638 219801A24F8191E00166