H3C WA5330, Manual, Page: 7 / 16

6
4.
Insert a screw anchor into each hole, and tap the screw anchor with a rubber hammer until it is
all flush with the wall surface, as shown in
Figure 9 .
Figure 9 Hammering the anchor
5.
Align the installation holes in the wall/ceiling bracket with the anchors and insert screws
through the installation holes into the screw anchors. Adjust the position of the wall/ceiling
bracket and fasten the screws.
Figure 10 Attaching the wall/ceiling bracket to the wall
6.
Align the two tabs on the AP bracket into the notches on the wall/ceiling bracket, and then
rotate the AP clockwise until it snaps into place, as shown in
Figure 11 .
Figure 11 Attaching the AP to the wall/ceiling bracket