23
Verifying the network connection
Verifying network connection for the fit AP
All settings of the fit AP are configured on the AC. Use the
display wlan ap all
command on the AC
that connects to the fit AP. If the AP status is
R/M
, the AP is connected to the network.
<AC> display wlan ap all
Total number of APs: 1
Total number of connected APs: 1
Total number of connected manual APs: 1
Total number of connected auto APs: 0
Total number of connected common APs: 1
Total number of connected WTUs: 0
Total number of inside APs: 0
Maximum supported APs: 3072
Remaining APs: 3070
Total AP licenses: 128
Remaining AP licenses: 127
AP information
State : I = Idle, J = Join, JA = JoinAck, IL = ImageLoad
C = Config, DC = DataCheck, R = Run M = Master, B = Backup
AP name APID State Model Serial ID
ap1 1 R WA4320X 219801A0REM153000023
Verifying network connection for the fat AP
Use the
ping
command on the fat AP to ping the uplink network device. If the ping operation
succeeds, the AP is connected to the network successfully.