34
Gigabitethernet1/0/1 enable
WLAN-BSS1 enable
Table 9
Command output
Field Description
Mac-address learning status of the switch
Global MAC address learning status (enabled or disabled).
PortName Port
name.
Learning Status
MAC address learning status (enabled or disabled) for a port.
mac-address (interface view)
Syntax
mac-address
{
dynamic
|
static
}
mac
-
address
vlan
vlan
-
id
undo mac-address
{
dynamic
|
static
}
mac
-
address
vlan
vlan
-
id
View
Ethernet interface view, WLAN-BSS interface view
Default level
2: System level
Parameters
dynamic
: Specifies dynamic MAC address entries. These entries can age.
static
: Specifies static MAC address entries. They do not age, but you can add or remove them.
mac
-
address
: Specifies a MAC address in the format of H-H-H, where 0s at the beginning of each H
(16-bit hexadecimal digit) can be omitted. For example, inputting "f-e2-1" indicates that the MAC
address is "000f-00e2-0001".
vlan
vlan
-
id
: Specifies an existing VLAN to which the Ethernet interface belongs, where
vlan-id
is the
specified VLAN ID, ranging from 1 to 4094.
Description
Use
mac-address
to add or modify a MAC address entry on a specified interface.
Use
undo mac-address
to remove a MAC address entry on the interface.
The MAC address entries configuration cannot survive a reboot unless you save it. The dynamic MAC
address table entries, however, are lost at next reboot whether or not you save the configuration.
Related commands:
display mac-address
.
Examples
# Add a static entry for MAC address 000f-e201-0101 on port GigabitEthernet 1/0/1 that belongs to
VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mac-address static 000f-e201-0101 vlan 2