Command Manual – Getting Started
H3C VG Series Voice Gateways
Chapter 1 Fundamental Configuration Commands
1-16
Last 5 minutes input rate 0.00 bytes/sec, 0.00 packets/sec
Last 5 minutes output rate 0.00 bytes/sec, 0.00 packets/sec
Input: 76 packets, 9858 bytes
70 broadcasts
6 errors, 0 runts, 0 giants
0 CRC,0 frame errors, 0 overrunners
0 aborted sequences 0 no buffers
0 packets with dribble condition detected
Output:28 packets, 1792 bytes
28 broadcasts
0 errors, 0 underruns, 0 collisions
0 packets had been deferred
1.3.6 duplex
Syntax
duplex
{
negotiation
|
full
|
half
}
undo duplex
View
Ethernet interface view
Parameter
negotiation
: Negotiation mode
full
: Full duplex mode
half
: Half duplex mode
Description
Use the
duplex
command to set the operating mode of the 10/100Base-TX Fast
Ethernet (FE) interface.
Use the
undo duplex
command to reset the interface mode to the default value.
By default, the Ethernet interface runs in negotiation mode.
When the VG is connected to HUB, it runs in half duplex mode. When connected to the
network device which supports full duplex mode and is set in full duplex mode, for
example LAN Switch, it runs in full duplex mode.
If you set the interface in negotiation mode, the peer interface must be also in
negotiation mode. It is recommended to use the
duplex
command to set both ends at
the same duplex mode if you are not sure they are in the same mode.
