Command Manual – Getting Started
H3C VG Series Voice Gateways
Chapter 1 Fundamental Configuration Commands
1-13
begin to bind.
Ethernet1: Send arp request for alloced address(192.168.70.1) success.
Ethernet1: Move to BOUND state in 1 seconds if received no arp reply.
%10:21:31: Line protocol ip on the interface Ethernet1 is UP
Ethernet1: Recv no arp reply for 192.168.70.1, begin to use the address.
Ethernet1: Process DHCP_CLIENT_KRT message if index(2), message type(1)
Ethernet1: FSM state transfer(REQUESTING-->BOUND) successfully.
1.3.2 debugging ethernet
Syntax
debugging ethernet
undo debugging ethernet
View
Any view
Parameter
None
Description
Use the
debugging ethernet
command to enable debugging for events of the Ethernet
interface.
Use the
undo debugging ethernet
command to disable debugging output.
Example
# Enable debugging for events of the Ethernet interface.
[VG] debugging ethernet
Ethernet0: Send a Ethernet_II frame.
Its Destination MAC address is:ff-ff-ff-ff-ff-ff
Its Source MAC address is:00-e0-fc-20-21-80
It's a arp datagram
1.3.3 debugging physical
Syntax
debugging physical
{
all
|
receive
|
transmit
} [
interface ethernet
interface-number
]
undo debugging physical
{
all
|
receive
|
transmit
} [
interface ethernet
interface-number
]
