Command Manual – Getting Started
H3C VG Series Voice Gateways
Chapter 1 Fundamental Configuration Commands
1-10
1.2.10 reboot
Syntax
reboot
[
mode
{
interval
{
hh:mm
|
mmm
} |
time
{
hh:mm
[
dd/mm/yyyy
] }
[
reason-string
] } ] [
reason reason-string
] [
cancel
]
View
System view
Parameter
mode
: Reboots the system at a preset time point or after a preset interval.
interval
{
hh:mm
|
mmm
}: Specifies an interval to reboot the system, in time form
(
hh:mm
) or in digit form (
mmm
). Value ranges 0~5999 minutes in digit form.
time
hh:mm
[
dd/mm/yyyy
]: Specifies a time point to reboot the system. If no date is
assigned, it is the current date.
reason-string
: Describes the reason for rebooting the system.
cancel
: Removes system rebooting at a preset time point or after a preset interval.
Description
Use the
reboot
command to reboot the VG.
This command is equivalent in function to powering off the VG. But in remote
maintenance mode, you can use this command to restart the VG remotely, instead of
going to the place where the VG is located and restarting it.
Using the command with the keyword
interval
or
time
, you can set system rebooting
after a preset interval or at a preset time. This helps in case of online program upgrade
and configuration modification. System rebooting is required before the upgraded
program takes effect and the same is true of modifying some special configurations.
But system rebooting is not recommended when an administrator is maintaining the
system, for this may disturb the normal services. This command enables you to select a
time when system rebooting does not disturb normal services or disturbs normal
services to the lowest degree.
You should decide whether to save configuration files before restarting the system with
this command.
Example
# Reboot the system.
[VG] reboot
WARNING: System will REBOOT! Continue?[Y/N]y
System is now rebooting, please wait.
