6-20
3.
Remove the access panel. Pressing the two unlock buttons on the access panel, slide the panel
toward the server rear, and then lift the panel to remove it.
4.
Remove the processor mezzanine board:
a.
Press the
UNLOCK
button to release the handle of the processor mezzanine board. The
handle automatically pops out.
b.
Remove the supercapacitors, if any.
c.
Hold the handle and lift the processor mezzanine board out of the chassis.
5.
Remove DIMMs from the processor mezzanine board.
6.
Remove processors from the processor mezzanine board.
7.
Install a protective cover for each processor socket.
Installing the processor mezzanine board
1.
Remove the protective cover from each processor socket.
2.
Install the removed processors.
3.
Install the removed DIMMs.
4.
Install the processor mezzanine board:
a.
Align the standouts at both sides of the board with the notches on the chassis edges, and
then place the processor mezzanine board in the chassis.
b.
Install the removed supercapacitors. Insert the connector end of a supercapacitor into the
supercapacitor holder. Pull the clip on the holder, insert the other end of the supercapacitor
into the holder, and then release the clip.
c.
Close the handle of the processor mezzanine board.
5.
Install the access panel. Place the access panel on top of the server chassis and slide the
access panel toward the server front until it snaps into place.
6.
Rack-mount the server. For more information, see "
7.
Connect the power cord. For more information, see "
8.
Power on the server. For more information, see "
Replacing a DIMM
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
The server supports DCPMMs and DRAM DIMMs (both LRDIMM and RDIMM supported).
Compared with DRAM DIMMs, DCPMMs provide larger capacity and can protect data from getting
lost in case of unexpected system failures.
Both DCPMMs and DRAM DIMMs are referred to as DIMMs in this document, unless otherwise
stated.
Guidelines
WARNING!
The DIMMs are not hot swappable.
