1
Overview
The information in this document might differ from your product if it contains custom configuration
options or features.
The model name of a hardware option in this document might differ slightly from its model name
label. A model name label might add a prefix or suffix to the hardware-coded model name for
purposes such as identifying the matching server brand or applicable region. For example, the
DDR4-2666-8G-1Rx8-R memory model represents memory module labels including
UN-DDR4-2666-8G-1Rx8-R, UN-DDR4-2666-8G-1Rx8-R-F, and UN-DDR4-2666-8G-1Rx8-R-S.
The figures in this document are for illustration only.
For more information about processor installation and replacement videos, visit H3C official website
at
http://www.h3c.com/cn/home/qr/default.htm?id=543
Processor kit
The processor kit for an H3C UniServer R6700 G3 server includes the following components:
•
Processor
•
Retaining bracket
•
Heatsink
Processor installation also requires a T30 Torx screwdriver. You need to prepare the screwdriver
yourself.
Preparing for installation
WARNING!
To reduce the risk of personal injury from hot surfaces, allow the server and the internal system
components to cool before touching them.
CAUTION:
•
To avoid processor and system board damage, only H3C-authorized personnel and
professional server engineers can install a processor.
•
To prevent ESD damage to electronic components, wear an ESD wrist strap before beginning
the installation procedure. Make sure the ESD wrist strap is reliably grounded.
To prepare the server for processor installation:
1.
Back up all server data.
2.
Power down the server.
3.
Disconnect the power cords.
4.
Remove the server from the rack.
5.
Remove the access panel. Pressing the two unlock buttons on the access panel, slide the
panel towards the rear of the server, and then lift the panel to remove it.
