78
NOTE:
•
Use transceiver modules for the fiber ports provided by H3C only. The router might be
incompatible with transceiver modules from other vendors. The system generates an alarm when
a transceiver module from another vendor is installed.
•
The BIDI modules must be used in pairs. For example, if you install the
SFP-GE-LX-SM1310-BIDI in the local port, you must install the SFP-GE-LX-SM1490-BIDI in the
peer port.
10 Gbps Ethernet port
The SR6602-X2 provides two 10 Gbps Ethernet ports. 10 Gbps SFP+ ports do not support 1000
Mbps transceiver modules.
Table 37 10 Gbps Ethernet port specifications
Item Specification
Protocol 802.3ae
Connector type
LC
Transceiver module type
SFP+
Physical layer
10GBASE-R/W
Transmission rate
•
LAN PHY
—10.3125 Gbps
•
WAN PHY
—9.95328 Gbps
Table 38 Transceiver modules for the SFP+ ports
Model
Central
wavelength
Connector
type
Fiber type
Max.
transmission
distance
SFP-XG-SX-MM850-
A
850 nm
LC
50/125µm multi-mode
300 m (984.25 ft)
SFP-XG-SX-MM850-
E
850 nm
LC
50/125µm multi-mode
300 m (984.25 ft)
SFP-XG-LX-SM1310 1310
nm
LC
9/125µm
single mode
10 km (6.21 miles)
SFP-XG-LX-SM1310
-E
1310 nm
LC
9/125µm single mode
10 km (6.21 miles)
SFP-XG-LH40-SM15
50
1550 nm
LC
9/125µm single mode
40 km (24.86 miles)
SFP-XG-LH80-SM15
50
1550 nm
LC
9/125µm single mode
80 km (49.71 miles)
Flexible interface platform modules
The SR6602-X Router Series supports flexible interface platform (FIP) modules FIP-10 and FIP-20.
You can install High-speed Interface Modules (HIMs) and Multifunctional Interface Modules (MIMs)
on a FIP to support different network services as needed. A FIP module is located on the lower part
of the front panel.