14
To install a HIM:
1.
Locate the slot to install the HIM on the FIP module.
A HIM occupies two slots of the FIP module.
2.
Loosen the captive screws on a filler panel with a Phillips screwdriver, and then use a flat-blade
screwdriver to prize the filler panel to remove it from the router.
Repeat the same step to remove the other filler panel. Keep the filler panels safe for future use.
3.
Use even pressure to push the HIM slowly along the slide rails into the slot, and then pull the
levers inward.
4.
Use a Phillips screwdriver to fasten the captive screws on the HIM.
Figure 12 Installing a HIM
Installing a MIM
NOTE:
Install the MIM in the lower slot on the FIP module.
To install a MIM:
1.
Locate the slot to install the MIM on the FIP module.
2.
Loosen the captive screws on a filler panel with a Phillips screwdriver, and then use a flat-blade
screwdriver to prize the filler panel to remove it from the router. Keep the filler panel safe for
future use.
3.
Use even pressure to push the MIM slowly along the slide rails into the slot, and then pull the
levers inward.
4.
Use a flat-blade screwdriver to fasten the captive screws on the MIM.
Figure 13 Installing the MIM