13
NOTE:
•
For the power module LED description, see “
•
An AC power module and a DC power module cannot be installed on the same router.
Installing a FIP module
NOTE:
Before you install a FIP module, make sure the ejector levers are in the open position away from the
FIP module panel.
The following uses a FIP-20 as an example.
1.
Locate the slot to install the FIP module, and remove the filler panel.
2.
Use a Phillips screwdriver to loosen the captive screws on the filler panel, and remove the filler
panel. Keep the filler panel safe for future use.
3.
Use even pressure to gently push the FIP module into the slot along the slide rails until
positioning pins on the backplane are seated in the positioning holes, and then push the ejector
levers inward to lock the FIP module in position.
4.
Fasten the captive screws on the FIP module with a Philips screwdriver.
Figure 11 Installing a FIP module
NOTE:
•
For more information about the FIP LEDs, see “
•
Do not insert or remove a HIM/MIM into or from a FIP module when the RUN LED on the FIP is
flashing fast. Otherwise, an exception may occur.
Installing a HIM
NOTE:
•
Only the FIP-20 supports HIMs.
•
Before you install a HIM, make sure the ejector levers are in the open position away from the HIM
module panel.