H3C SR6602-X, Configuration Manual

Page: 36 / 65

29
Step Command Remarks
23. Shut down and bring up the
interface.
shutdown
undo shutdown
By default, a standard POS
interface is up.
For the settings to take effect, you
must perform this step.
If no cable is connected to the
interface, shut down the interface
to prevent interface exceptions.
Configuring a POS subinterface
Step Command Remarks
1. Enter system view.
system-view N/A
2. Create a POS subinterface
and enter its view.
interface pos
interface-number.subnumber
[ p2mp | p2p ]
You can create POS
subinterfaces only on Frame
Relay-enabled standard POS
interfaces.
3. Configure the subinterface
description.
description text
By default, the description of a
POS subinterface is
interface
name Interface , for example,
Pos1/1/1.1 Interface.
4. Set the MTU.
mtu size The default setting is 1500 bytes.
5. Configure the expected
bandwidth of the
subinterface.
bandwidth bandwidth-value
By default, the expected
bandwidth (in kbps) is the
interface baud rate divided by
1000.
6. Restore the default settings
for the POS subinterface.
default
N/A
7. Shut down and bring up the
POS subinterface.
shutdown
undo shutdown
By default, a POS subinterface is
up.
For the settings to take effect, you
must perform this step.
Configuring a POS channel interface
POS channel interfaces are created through channelization of a high-speed CPOS interface. They
work in the same way as POS interfaces. For more information about creating POS channel
interfaces, see "
Configuring CPOS interfaces ."
To configure a POS channel interface:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter POS channel interface
view.
interface pos interface-number N/A
3. (Optional.) Configure the
interface description.
description text
By default, the description of a
POS channel interface is
interface
name Interface , for example,
Pos1/1/1:0 Interface.