11
Step Command
Remarks
3.
Enable subinterface rate
statistics collection on the
Ethernet interface.
sub-interface rate-statistic
By default, subinterface rate
statistics collection is disabled on
an Ethernet interface.
Configuring a Layer 3 Ethernet interface or
subinterface
Setting the MTU for an Ethernet interface or subinterface
The maximum transmission unit (MTU) of an Ethernet interface affects the fragmentation and
reassembly of IP packets on the interface. Typically, you do not need to modify the MTU of an
interface.
To set the MTU for an Ethernet interface or subinterface:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Ethernet interface
or subinterface view.
interface
interface-type
{
interface-number
|
interface-number.subnumber
}
N/A
3.
Set the MTU of the
Ethernet interface or
subinterface.
mtu
size
The default setting is 1500
bytes.
Changing the interface type
For interfaces on HIM-TS8P interface modules, you can change the interface type between POS and
GigabitEthernet. When you change the interface type, the system removes the original interface, and
then creates a new-type interface with the same number as the original interface.
Changing a Layer 3 GigabitEthernet interface to a standard POS interface
Step Command Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Layer 3
GigabitEthernet interface
view.
interface gigabitethernet
interface-number
N/A
3.
Change the interface to a
standard POS interface.
port-type switch pos
The device enters standard
POS interface view
automatically after you execute
this command.
Changing a standard POS interface to a Layer 3 GigabitEthernet interface
Step Command Remarks
1.
Enter system view.
system-view
N/A
2.
Enter standard POS
interface view.
interface pos
interface-number
N/A
Summary of Contents for SR6602-X
Page 55: ...48...
