H3C SOHO IE4300, Command Reference Manual

Page: 3085 / 3296

22
Usage guidelines
When you use this command to create a Tcl-defined policy, follow these guidelines:
Make sure the script file is saved on all IRF member devices. This practice ensures that the policy
can run correctly after a master/subordinate switchover occurs or the member device where the
script file resides leaves the IRF.
This command both creates and enables the specified Tcl-defined monitor policy. To revise the Tcl
script of a Tcl-defined policy, you must suspend all monitor policies first, and then resume the policies
after you finish revising the script. The system cannot execute a Tcl-defined policy if you edit its Tcl
script without suspending all monitor policies.
To bind a Tcl-defined policy to a different Tcl script file:
1. Execute the
undo rtm tcl-policy
command to delete the Tcl policy.
2. Create the Tcl policy again, and then bind it to the new Tcl script file.
You can assign the same policy name to a CLI-defined policy and a Tcl-defined policy. However, you
cannot assign the same name to policies that are the same type.
Examples
# Create a Tcl policy and bind it to a Tcl script file.
<Sysname> system-view
[Sysname] rtm tcl-policy test test.tcl
running-time
Use
running-time
to configure the action runtime of a CLI-defined policy.
Use
undo running-time
to restore the default.
Syntax
running-time time
undo running-time
Default
The action runtime of a CLI-defined policy is 20 seconds.
Views
CLI-defined policy view
Predefined user roles
network-admin
Parameters
time
: Specifies the action runtime in the range of 0 to 31536000 seconds. If you specify 0, the policy
runs its actions forever once the policy is triggered.
Usage guidelines
The action runtime limits the amount of time that the monitor policy runs its actions from the time it is
triggered. When the runtime is reached, the system stops executing the actions even if the execution
is not finished.
This setting prevents an incorrectly defined policy from running its actions permanently to occupy
resources.
Examples
# Set the action runtime to 60 seconds for CLI-defined policy test .