H3C SOHO IE4300, Command Reference Manual

Page: 2686 / 3296

2
Predefined user roles
network-admin
network-operator
Parameters
group-id
: Specifies a smart link group by its ID. The value range for this argument is 1 to 48.
all
: Displays information about all smart link groups.
Examples
# Display information about smart link group 1.
<Sysname> display smart-link group 1
Smart link group 1 information:
Device ID : 0011-2200-0001
Preemption mode : None
Preemption delay: 1(s)
Control VLAN : 1
Protected VLAN : Reference Instance 2, 4
Member Role State Flush-count Last-flush-time
-----------------------------------------------------------------------------
GE1/0/1 PRIMARY ACTIVE 1 16:45:20 2012/04/21
GE1/0/2 SECONDARY STANDBY 2 16:37:20 2012/04/21
Table 2 Command output
Field Description
Preemption mode
Preemption mode:
•
None —Preemption disabled.
•
Role —Role preemption mode.
•
Speed —Speed preemption mode.
Preemption delay Preemption delay time, in seconds.
Control-VLAN Control VLAN ID.
Protected VLAN
Protected VLANs of the smart link group. Referenced Multiple Spanning
Tree Instances (MSTIs) are displayed. To view the VLANs mapped to the
referenced MSTIs, use the
display stp
region-configuration
command.
Member Member port of the smart link group.
Role Port role: primary or secondary.
State Port state: active, down, or standby.
Flush-count Number of transmitted flush messages.
Last-flush-time
Time when the last flush message was transmitted (NA indicates that no
flush message has been transmitted).
flush enable
Use
flush enable
to enable flush update.
Use
undo flush enable
to disable flush update.