H3C SOHO IE4300, Command Reference Manual

Page: 2658 / 3296

14
[Sysname-rrpp-domain1] control-vlan 100
[Sysname-rrpp-domain1] protected-vlan reference-instance 0 1 2
[Sysname-rrpp-domain1] ring 10 node-mode master primary-port gigabitethernet 1/0/1
secondary-port gigabitethernet 1/0/2 level 0
# Specify the device as the transit node of primary ring 10 in RRPP domain 1. Specify
GigabitEthernet 1/0/1 as the primary port and GigabitEthernet 1/0/2 as the secondary port. Specify
the device as the edge node of subring 20 in RRPP domain 1, and specify GigabitEthernet 1/0/3 as
the edge port.
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 100
[Sysname-rrpp-domain1] protected-vlan reference-instance 0 1 2
[Sysname-rrpp-domain1] ring 10 node-mode transit primary-port gigabitethernet 1/0/1
secondary-port gigabitethernet 1/0/2 level 0
[Sysname-rrpp-domain1] ring 20 node-mode edge edge-port gigabitethernet 1/0/3
Related commands
ring enable
ring enable
Use
ring enable
to enable an RRPP ring.
Use
undo ring enable
to disable the RRPP ring.
Syntax
ring ring-id enable
undo ring ring-id enable
Default
An RRPP ring is disabled.
Views
RRPP domain view
Predefined user roles
network-admin
Parameters
ring-id
: Specifies an RRPP ring by its ID in the range of 1 to 128.
Usage guidelines
To activate an RRPP ring, you must enable RRPP and the RRPP ring.
Before you enable subrings on a device, you must enable the primary ring. Before you disable the
primary ring on the device, you must disable all subrings. Otherwise, the system displays error
prompts.
Examples
# Enable RRPP ring 10 in RRPP domain 1.
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 100
[Sysname-rrpp-domain1] protected-vlan reference-instance 0 1 2