Operation Manual – User Access
H3C SecPath Series Security Products
Chapter 3 PPPoE Client Configuration
3-3
Table 3-1
Configuring a Dialer interface
Operation
Command
Configure a Dialer Rule
dialer-rule
dialer-group
{
protocol-name
{
permit
|
deny
} |
acl
acl-number
}
Create a dialer interface
interface dialer
number
Set a remote user name
dialer user username
Configure IP address of the interface.
ip address
{
address mask
|
ppp-negotiate
}
Configure the Dialer Bundle on an
interface
dialer bundle
bundle-number
Configure the Dialer Group on an
interface
dialer-group
group-number
PPPoE only supports Resource-Shared DCC. As needed, such parameters as PPP
authentication may also be necessarily configured on a dialer interface. For more
information on how to configure a dialer interface, refer to the chapter discussing DDD
configurations in the “Dial-up” part of this manual.
3.2.2 Configuring a PPPoE Session
PPPoE session can be configured on a physical Ethernet interface or a virtual Ethernet
(VE) interface created on an ADSL interface. When a firewall is to be linked to the
Internet through an ADSL interface, it is necessary to configure PPPoE session on the
virtual Ethernet interface; when a firewall is to be linked to an ADSL Modem and then
the Internet via an Ethernet interface, it is necessary to configure the PPPoE session
on the Ethernet interface.
Configure a virtual Ethernet interface in system view and PPPoEoA mapping in PVC
view.
Table 3-2
Configuring a virtual Ethernet interface
Operation
Command
Create a virtual Ethernet interface
interface virtual-ethernet number
Delete the virtual Ethernet interface
undo interface virtual-ethernet
number
Perform the following configuration in Ethernet interface view or virtual Ethernet
interface view.
