Command Manual – User Access
H3C SecPath Series Security Products
Chapter 3 PPPoE Client Configuration Commands
3-3
3.1.4 dialer-group
Syntax
dialer-group group-number
undo dialer-group
View
Dialer interface view
Parameter
group-number
:
Sequence number of dialer access group, ranges from 1 to 255. This
group is set through the
dialer-rule
command.
Description
Use the
dialer-group
command to configure access control on the packets transmitted
on a DCC interface and place the interface in a dialer access group.
Use the
undo dialer-group
command to cancel the interface from the dialer access
group.
By default, the interface is not placed in the dialer access group.
This command is used for associating a physical interface with a dialer access group.
Through the
dialer-rule
command, you can associate a dialer access group.
With the
acl
command. A DCC interface can only be the member of a dialer access group. If it is
configured to be a member of another a dialer access group, this configuration will
replace the previous one.
Note:
In the default configuration of the interface,
dialer-group
is not configured. You must
configure this command. Otherwise, DCC will be unable to transmit packets.
Related command:
dialer-rule
.
Example
# Add the Dialer 1 interface to dialer-group 1.
[H3C] dialer-rule 1 acl 3101
[H3C] interface dialer1
[H3C-dialer1] dialer-group 1
