2-18
Figure2-22 Connecting the AC power cord for a PSR1600B-12A-B power module
(1) Releasable cable tie
(2) Lock the cable tie to secure the power cord to the handle of the power module
Installing and removing interface modules
CAUTION:
When you install or remove an interface module, follow these guidelines:
•
Never touch the components on the interface module.
•
Do not use excessive force.
The switch provides eight interface module slots. For the interface modules available for the switch
and the interface module specifications, see "Interface modules." The following procedures install
and remove an LSWM116H interface module.
Installing an interface module
1.
Wear an ESD wrist strap and make sure the wrist strap makes good skin contact and is reliably
grounded.
2.
Remove the filler panel, if any, from the target interface module slot. As shown in
put your thumb and forefinger into the two holes of the filler panel. Then press down the metal
tab in the top hole and pull out the filler panel along the guide rails.
1
2
