2-14
Figure2-21 Mounting brackets and grounding cable installation positions on the S9850-32H
switch
(1) Power module-side installation position for the mounting bracket
(2) Primary grounding point
(3) Auxiliary grounding point
(4) Port-side installation position for the mounting bracket
Attaching the mounting brackets and chassis rails to the
chassis
1.
Place the wide flange of the mounting bracket against the chassis side panel. Align the
mounting bracket installation holes with the appropriate screw holes in the chassis. Use the
provided M4 screws to attach the mounting bracket to the chassis (recommended torque: 12
kgf-cm).
To install the mounting brackets at the port-side mounting position, see
and
Use four installation holes to secure the mounting brackets to the S6850-56HF, S6850-2C,
and S9850-4C switches. Use three installation holes to secure the mounting brackets to the
S9850-32H switch.
To install the mounting brackets at the power module-side mounting position, see
and
Use four installation holes to secure the mounting brackets to the switch.
2.
Determine the installation position of the chassis rails based on the position of mounting
brackets and the distance between the front and rear rack posts.
Table2-4 Chassis rail installation position
Switch model
Mounting bracket
position
Distance between the front
and rear rack posts
Chassis rail
installation
position
S6850-56HF
(long slide rails)
Port-side mounting
position, as shown in
692 to 788 mm (27.24 to 31.02 in)
Position a
692 to 853 mm (27.24 to 33.58 in)
Position b
Power module-side
mounting position, as
shown in
692 to 788 mm (27.24 to 31.02 in)
Position c
692 to 853 mm (27.24 to 33.58 in)
Position d
1
2
3
4