H3C S6850 Series, Configuration Manual

Page: 197 / 394

55
{
port link-type hybrid
7. Configure the port to operate in automatic voice VLAN assignment mode.
voice-vlan mode auto
By default, the automatic voice VLAN assignment mode is enabled.
8. Enable the voice VLAN feature on the port.
voice-vlan vlan-id enable
By default, the voice VLAN feature is disabled.
Before you execute this command, make sure the specified VLAN already exists.
Configuring a port to operate in manual voice VLAN
assignment mode
Restrictions and guidelines
•
You can configure different voice VLANs for different ports on the same device. Make sure the
following requirements are met:
{
One port can be configured with only one voice VLAN.
{
Voice VLANs must be existing static VLANs.
•
Do not enable voice VLAN on the member ports of a link aggregation group. For more
information about link aggregation, see "Configuring Ethernet link aggregation."
•
To make a voice VLAN take effect on a port operating in manual mode, you must manually
assign the port to the voice VLAN.
Procedure
1. Enter system view.
system-view
2. (Optional.) Enable the voice VLAN security mode.
voice-vlan security enable
By default, the voice VLAN security mode is enabled.
3. (Optional.) Add an OUI address for voice packet identification.
voice-vlan mac-address oui mask oui-mask [ description text ]
By default, system default OUI addresses exist. For more information, see Table 1 .
4. Enter Layer 2 Ethernet interface view.
interface interface-type interface-number
5. Configure the port to operate in manual voice VLAN assignment mode.
undo voice-vlan mode auto
By default, a port operates in automatic voice VLAN assignment mode.
6. Assign the access, trunk, or hybrid port to the voice VLAN.
{
For the access port, see " Assigning an access port to a VLAN ."
{
For the trunk port, see " Assigning a trunk port to a VLAN ."
{
For the hybrid port, see " Assigning a hybrid port to a VLAN ."
After you assign an access port to the voice VLAN, the voice VLAN becomes the PVID of the
port.
7. (Optional.) Configure the voice VLAN as the PVID of the trunk or hybrid port.
{
For the trunk port, see " Assigning a trunk port to a VLAN ."
{
For the hybrid port, see " Assigning a hybrid port to a VLAN ."