28
4.
Replace the peer port with a new one to verify that the peer port is operating correctly.
5.
If the issue persists, contact H3C Support.
Non-H3C transceiver module error message
Symptom
The output from the
display logbuffer
command shows that the transceiver module is not an H3C
transceiver module.
<Sysname> display logbuffer
Twenty-FiveGigE1/0/5: This transceiver is NOT sold by H3C. H3C therefore shall NOT
guarantee the normal function of the device or assume the maintenance responsibility
thereof!
Troubleshooting flowchart
Figure 9 Troubleshooting non-H3C transceiver module error message
Solution
To resolve the issue:
1.
Verify that the transceiver module is an H3C transceiver module:
Execute the
display transceiver interface
command to view the vendor name of the
transceiver module.
[Sysname] display transceiver interface twenty-fivegige 1/0/1
Twenty-FiveGigE 1/0/1 transceiver information:
Transceiver Type : 40G_BASE_LR4_QSFP_PLUS
Connector Type : LC
Wavelength(nm) : 1301
Transfer Distance(km) : 10(SMF)
Digital Diagnostic Monitoring : YES
Vendor Name : H3C
Ordering Name : QSFP-40G-LR4-WDM1300
Is the vendor name H3C?
H3C transceiver module?
Replace it with an H3C
transceiver module
Replace it with an H3C
transceiver module
No
Yes
No
Yes
No
Yes
Yes
No
Resolved?
Contact the support
Non-H3C transceiver module
reported in system logs
End
Resolved?
