3-4
Figure 3-5 Completing the device driver installation wizard
Setting terminal parameters
To configure and manage the switch through the console port, you must run a terminal emulator
program, TeraTermPro or PuTTY, on your PC. You can use the emulator program to connect a
network device, a Telnet site, or an SSH site. For more information about the terminal emulator
programs, see the user guides for these programs.
The following are the required terminal settings:
•
Bits per second
—9,600.
•
Data
bits
—8.
•
Parity
—None.
•
Stop
bits
—1.
•
Flow
control
—None.
Starting the switch
Pre-start checklist
Before powering on the switch, verify the following items:
•
The power cord is correctly connected.
•
The input power voltage is as required by the switch.
•
The console cable is correctly connected.
•
The PC has started, and the terminal parameters have been correctly configured.
