45
The candidate port at the top is chosen as the reference port. If two ports have the same port priority,
duplex mode, and speed, the original Selected port is chosen. If more than one such original Selected
port exists, the one with the lower port number is chosen.
Setting the aggregation state of each member port
After a static aggregation group reaches the limit on Selected ports, ports attempting to join the group
are put in Unselected state. This prevents traffic interruption on the existing Selected ports.
Figure 9
Setting the aggregation state of a member port in a static aggregation group
For more information about configuring the maximum number of Selected ports in a static aggregation
group, see "
Setting the minimum and maximum numbers of Selected ports for an aggregation group
Any operational key or attribute configuration change might affect the aggregation states of link
aggregation member ports.
Aggregating links in dynamic mode
Dynamic aggregation mode is implemented through IEEE 802.3ad Link Aggregation Control Protocol
(LACP).
