7
Figure 4
Front mounting bracket
(1) Hole for attaching the bracket to a rack
(2) Hole for attaching the bracket to the switch chassis
Figure 5
Rear mounting bracket and load-bearing screw
(1) Hole for attaching the bracket to a rack
(2) Load-bearing screw
Rack-mounting by using the front mounting brackets
To rack-mount the switch by using the front mounting brackets, you can only attach the front mounting
brackets to the middle mounting position on the switch.
To install the switch in a 19-inch rack by using the front mounting brackets:
1.
Wear an ESD wrist strap and make sure the wrist strap makes good skin contract and is reliably
grounded.
2.
Align the round holes in the wide flange of one front mounting bracket with the screw holes in the
middle mounting position of the chassis.
3.
Use M4 screws to attach the mounting bracket to the chassis.
4.
Repeat the proceeding two steps to attach the other mounting bracket to the chassis.
