Command Manual – AAA&RADIUS&HWTACACS
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
1-46
z
The
undo radius scheme
command cannot be used to delete the default
RADIUS scheme. In addition, you cannot delete a RADIUS scheme which is being
used by an online user.
Related command:
key
,
retry realtime-accounting
,
timer realtime-accounting
,
stop-accounting-buffer enable
,
retry stop-accounting
,
server-type
,
state
,
user-name-format
,
retry
,
display radius
and
display radius statistics
.
Example
# Create a RADIUS scheme named radius1 and enter its view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1]
1.2.15 radius trap
Syntax
radius trap
{
accounting-server-down
|
authentication-server-down
}
undo radius trap
{
accounting-server-down
|
authentication-server-down
}
View
System view
Parameter
accounting-server-down
: Enables sending traps when the RADIUS accounting
server gives no response.
authentication-server-down
: Enables sending traps when the RADIUS
authentication server gives no response.
Description
Use the
radius trap
command to enable the RADIUS trap function.
Use the
undo radius trap
command to disable the RADIUS trap function.
By default, RADIUS trap is disabled.
After the RADIUS trap function is enabled, the following happens. If the RADIUS server
does not respond to the accounting or authentication request packets from an NAS, the
NAS retransmits accounting or authentication request packets to the server. When the
number of packet transmissions from the NAS to the server reaches one half of the
maximum transmission number, the system sends a trap message once; when this
number reaches the maximum, the system sends a trap message once again.
