Command Manual – AAA&RADIUS&HWTACACS
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
1-44
z
After the RADIUS client port is disabled, the sending of real-time
accounting-request packets buffered fails and these packets will be removed for
the buffer after the number of sending failures reaches the limit.
Related command:
radius scheme
1.2.13 radius nas-ip
Syntax
radius nas-ip ip-address
undo radius nas-ip
View
System view
Parameter
ip-address
: Source IP address, an IP address of this device. This address cannot be an
all-zero address, class D address, or loopback address.
Description
Use the
radius nas-ip
command to set the source IP address used by the switch to
send RADIUS packets.
Use the
undo radius nas-ip
command to restore the default setting.
By default, no source IP address is specified, and the IP address of the outbound
interface is used as the source IP address of the packet.
Note:
The
nas-ip
command in RADIUS scheme view has the same function as the
radius
nas-ip
command in system view; and the priority of configuration in RADIUS scheme
view is higher than in system view.
Note that:
z
You can specify the source IP address used to send RADIUS packet to prevent
the unreachability of the packets returned from the server due to physical interface
trouble. It is recommended to use the loopback interface address as the source IP
address.
z
You can specify only one source IP address by using this command. When you
use this command again, the newly specified source IP address will overwrite the
old one.
