Operation Manual – Multicast Protocol
H3C S5500-SI Series Ethernet Switches
Chapter 1 IGMP Snooping Configuration
1-9
To do...
Use the command...
Remarks
Configure router port
aging time
igmp-snooping
router-aging-time
interval
Optional
105 seconds by default
Configure member port
aging time
igmp-snooping
host-aging-time interval
Optional
260 seconds by default
1.4 Configuring Port Functions
1.4.1 Configuration Prerequisites
Before configuring port functions, complete the following task:
z
Enable IGMP Snooping in the VLAN
Before configuring port functions, prepare the following data:
z
Multicast group and multicast source addresses
z
Whether to enable the fast leave feature
z
Whether to enabled IGMP report suppression
1.4.2 Configuring Static Ports
If the host attached to a port needs to receive multicast data addressed to a particular
multicast group or from a particular multicast source/group, you can configure this port
to be a static member port of that multicast group or multicast source/group.
In a network with a stable topology structure, you can configure router ports of a switch
into static router ports, through which the switch can receive IGMP messages from
routers.
Follow these steps to configure static ports:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter
Ethernet
port view
interface
interface-type
interface-number
Enter
the
corre
spon
ding
view
Enter port
group view
port-group
{
manual port-group-name
|
aggregation agg-id
}
Use either
command
Configure a static
member port
igmp-snooping static-group
group-address
[
source-ip
source_address
]
vlan
vlan-id
Required
Disabled by default
Configuring a static
router port
igmp-snooping static-router-port
vlan
vlan-id
Required
Disabled by default
