2-15
Installing a PSR180-56A, PSR360-56A, PSR560-56D,
PSR720-56A, or PSR1110-56A power supply
The installation procedure is the same for the PSR180-56A, PSR360-56A, PSR560-56D,
PSR720-56A, and PSR1110-56A power supplies. The following procedure installs a PSR360-56A
power supply.
To install a PSR360-56A power supply:
1.
Wear an ESD wrist strap. Make sure the strap makes good skin contact and is reliably
grounded.
2.
Remove the filler panel, if any, from the target power supply slot.
Put your forefinger into the hole in the filler panel and then pull the filler panel out of the slot
gently.
Keep the removed filler panel secure for future use.
Figure2-21 Removing the filler panel from the target power supply slot
3.
Unpack the power supply. Make sure the power supply model is as required.
Keep the packaging box and packaging bag for the power supply secure for future use.
4.
Correctly orient the power supply. Make sure the lettering on the power supply is upward.
5.
Align the power supply with the power supply slot. Grasping the handle of the power supply
with one hand and supporting its bottom with the other, slide the power supply slowly into the
slot along the guide rails until the latch of the power supply clicks into the slot.
To prevent damage to the power supply or the connectors on the backplane, insert the power
supply gently. If you encounter a hard resistance when inserting the power supply, pull out the
power supply and insert it again.
