H3C S5120-EI Series, Operation Manual

Page: 1080 / 1191

1-10
To do… Use the command… Remarks
Configure the test type as
HTTP and enter test type view
type http
Required
Configure the destination
address for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address for a test
operation is the IP address of the
HTTP server.
Configure the source IP
address of a probe request
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be that
of an interface on the device and the
interface must be up. Otherwise, the
test will fail.
Configure the operation type
operation
{
get
|
post
}
Optional
By default, the operation type for the
HTTP is
get
, that is, obtaining data
from the HTTP server.
Configure the website that an
HTTP test visits
url url
Required
Configure the HTTP version
used in the HTTP test
http-version v1.0
Optional
By default, HTTP 1.0 is used in an
HTTP test.
Configure common optional
parameters
See Configuring Optional
Parameters Common to an
NQA Test Group
Optional
The TCP port number for the HTTP server must be 80 in an HTTP test. Otherwise, the test will fail.
Configuring a UDP Jitter Test
It is recommended not to perform an NQA UDP jitter test on known ports, namely, ports from 1 to 1023.
Otherwise, the NQA test will fail or the corresponding services of this port will be unavailable.
Real-time services such as voice and video have high requirements on delay jitters. With the UDP jitter
test, uni/bi-directional delay jitters can be obtained to judge whether a network can carry real-time
services.