Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches
Chapter 2 IPv6 RIPng Configuration
2-7
Follow these steps to configure a RIPng priority:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter RIPng view
ripng
[
process-id
]
—
Configure a RIPng priority
preference
[
route-policy
route-policy-name
]
preference
Optional
By default, the RIPng
priority is 100.
2.3.6 Configuring RIPng Route Redistribution
Follow these steps to configure RIPng route redistribution:
To do...
Use the command...
Remarks
Enter system view
system-view
––
Enter RIPng view
ripng
[
process-id
]
––
Configure a default
routing metric for
redistributed routes
default cost cost
Optional
By default, the default
metric of redistributed
routes is 0.
Redistribute routes from
another routing protocol
import-route
protocol
[
process-id
]
[
allow-ibgp
] [
cost cost
|
route-policy
route-policy-name
] *
Required
No route redistribution is
configured by default.
2.4 Tuning and Optimizing the RIPng Network
This section describes how to tune and optimize the performance of the RIPng network
as well as applications under special network environments. Before tuning and
optimizing the RIPng network, complete the following tasks:
z
Configure a network layer address for each interface
z
Configure the basic RIPng functions
This section covers the following topics:
z
z
Configuring Split Horizon and Poison Reverse
z
Configuring Zero Field Check on RIPng Packets
z
Configuring the Maximum Number of Equal Cost Routes for Load Balancing
