Operation Manual – Login
H3C S3610&S5510 Series Ethernet Switches
Chapter 2 Logging in Through the Console Port
2-12
Scenario
Authentication
mode
User type
Command
Command
level
The user privilege level
level
command already
executed
Determined
by the
level
argument
2.5.2 Configuration Example
I. Network requirements
Assume the switch is configured to allow you to login through Telnet, and your user
level is set to the administrator level (level 3). After you telnet to the switch, you need to
limit the Console user at the following aspects.
z
The user is authenticated against the local password when logging in through the
Console port.
z
The local password is set to 123456 (in plain text).
z
The commands of level 2 are available to users logging into the AUX user
interface.
z
The baud rate of the Console port is 19,200 bps.
z
The screen can contain up to 30 lines.
z
The history command buffer can store up to 20 commands.
z
The timeout time of the AUX user interface is 6 minutes.
II. Network diagram
Figure 2-6
Network diagram for AUX user interface configuration (with the
authentication mode being password)
III. Configuration procedure
# Enter system view.
<H3C> system-view
