Operation Manual – MSTP
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 MSTP Configuration
1-46
To do...
Use the command...
Remarks
Enable No Agreement
Check
stp
no-agreement-check
Required
Not enabled by default
Note:
The No Agreement Check feature can only take effect on the root port or Alternate port
after enabled.
1.8.3 Configuration Example
I. Network requirements
z
Device A connects to a third-party’s device that has different MSTP
implementation. Both switches are in the same region.
z
Another vendor’s device is the regional root bridge, and Device A is the
downstream device.
II. Network diagram
Figure 1-11
No Agreement Check configuration
III. Configuration procedure
# Enable No Agreement Check on Ethernet 1/0/1 of Switch A.
<DeviceA> system-view
[DeviceA] interface Ethernet 1/0/1
[DeviceA-Ethernet1/0/1] stp no-agreement-check
1.9 Configuring Protection Functions
An MSTP-compliant device supports the following protection functions:
z
BPDU guard
