Operation Manual – QinQ-BPDU Tunneling
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 QinQ Configuration
1-4
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter
Ethernet
port view
interface interface-type
interface-number
Enter
Ethernet
port view
or port
group
view
Enter
interface
group
view
port-group
{
manual
port-group-name |
aggregation
agg-id
}
Required
Use either command.
Configurations made in
Ethernet port view will take
effect on the current port
only; configuration made in
port group view will take
effect on all ports in the port
group.
Enable QinQ on the
port(s)
qinq enable
Required
Disabled by default.
1.3 Configuring Selective QinQ
The outer VLAN tag added to a frame by the basic QinQ feature is the VLAN tag
corresponding to the port’s default VLAN ID, while the selective QinQ feature allows
adding different outer VLAN tags based on different inner VLAN tags.
With selective QinQ configured on a port, the device will add different outer VLAN tags
based on the inner VLAN tags; frames with a VLAN ID out of the range specified in the
raw-vlan-id inbound
command will be forwarded unchanged.
Follow these steps to configure selective QinQ:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter
Ethernet
port view
interface interface-type
interface-number
Enter
Ethernet port
view or port
group view
Enter
interface
group view
port-group
{
manual
port-group-name |
aggregation
agg-id
}
Required
Use either command.
Configurations made in
Ethernet port view will
take effect on the current
port only; configurations
made in port group view
will take effect on all
ports in the port group.
Enter QinQ view and
configure the outer VLAN
tag for the port to add
qinq vid vlan-id
Required
Configure inner VLAN tags
corresponding to the outer
VLAN tags
raw-vlan-id inbound
{
all
|
vlan-id-list
}
Required
