Operation Manual – SSH
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 SSH Configuration
1-15
To do…
Use the command…
Remarks
Display the mappings
between host public keys
and SSH servers saved
on a client
display ssh server-info
Available in any
view
Display information about
a specified or all SSH
users on the SSH server
display ssh user-information
[
username
]
Available in any
view
1.5 SSH Server Configuration Examples
1.5.1 When Using Password Authentication
I. Network requirements
z
The host (SSH client) and the switch (SSH server) are directly connected through
the Ethernet interfaces.
z
The host runs SSH client software to securely log on to the switch for
configuration.
z
Password authentication is used.
II. Network diagram
Figure 1-2
SSH server configuration (using password authentication)
III. Configuration procedure
1)
Configure the SSH server
# Generate an RSA key pair and enable SSH server.
<Switch> system-view
[Switch] public-key local create rsa
[Switch] ssh server enable
# Configure an IP address for VLAN-interface 1, which the SSH client will use as the
destination for SSH connection.
[Switch] interface vlan-interface 1
[Switch-Vlan-interface1] ip address 192.168.1.40 255.255.255.0
[Switch-Vlan-interface1] quit
# Set the authentication mode for the user interface to AAA.
