251
duplicates. For more information about port mirroring, see
Network Management and Monitoring
Configuration Guide
.
•
Enabling MVRP on a Layer 2 aggregate interface enables both the aggregate interface and all
Selected member ports in the link aggregation group to participate in dynamic VLAN registration
and deregistration.
Configuration procedure
To enable MVRP:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable MVRP globally.
mvrp global enable
By default, MVRP is globally
disabled.
To enable MVRP on a port, first
enable MVRP globally.
3.
Enter interface view.
•
Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface
interface-type
interface-number
•
Enter port group view:
port-group
manual
port-group-name
Use one of the commands.
4.
Configure the port to permit
the specified VLANs.
port trunk permit vlan {
vlan-list
|
all }
By default, a trunk port permits only
VLAN 1.
Make sure that the trunk port
permits all registered VLANs.
For more information about the
port trunk permit vlan
command,
see
Layer 2
—
LAN Switching
Command Reference
.
5.
Enable MVRP on the port.
mvrp enable
By default, MVRP is disabled on a
port.
Configuring the MVRP registration mode
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
•
Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface
interface-type
interface-number
•
Enter port group view:
port-group
manual
port-group-name
Use one of the commands.
