89
Step Command
Remarks
3.
Configure the port
priority.
•
In STP/RSTP mode:
stp port priority
priority
•
In PVST mode:
stp vlan
vlan-list
port priority
priority
•
In MSTP mode:
stp
[
instance
instance-id
]
port priority
priority
Use one of the
commands.
The default setting is
128.
Configuring the port link type
A point-to-point link directly connects two devices. If two root ports or designated ports are connected
over a point-to-point link, they can rapidly transit to the forwarding state after a proposal-agreement
handshake process.
Configuration restrictions and guidelines
•
You can configure the link type as point-to-point for a Layer 2 aggregate interface or a port that
operates in full duplex mode. H3C recommends you to use the default setting and let the device to
automatically detect the port link type.
•
The
stp point-to-point force-false
or
stp point-to-point force-true
command configured on a port in
MSTP or PVST mode takes effect on all MSTIs or VLANs.
•
If the physical link to which the port connects is not a point-to-point link but you set it to be one, the
configuration might bring a temporary loop.
Configuration procedure
To configure the link type of a port or a group of ports:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view or
port group view.
•
Enter Layer 2 Ethernet interface view or Layer
2 aggregate interface view:
interface
interface-type interface-number
•
Enter port group view:
port-group manual
port-group-name
Use one of the
commands.
3.
Configure the port link
type.
stp point-to-point
{
auto
|
force-false
|
force-true
}
By default, the link type is
auto
where the port
automatically detects the
link type.
Configuring the mode a port uses to
recognize/send MSTP packets
A port can receive/send MSTP packets in the following formats:
•
dot1s
—802.1s-compliant standard format
